FhSim  3.1.0
Marine systems simulation
Loading...
Searching...
No Matches
Hydrodynamic cable

A cable object with dynamic stiffness and hydrodynamic loading.

+ Collaboration diagram for Hydrodynamic cable:
Author
Karl-Johan Reite

This class simulates a cable object consisting of one or more elements. Each element is of type CableElDynStiff. Each element has methods to make it possible to use larger time steps in the integration. This is done by decreasing the stiffness of the element until the eigenfrequency of the element is low enough for the integration to be performed with the defined maximum step size.

Each element is regarded as a straight segment, responsible for calculating the forces acting on each of its ends, as well as the mass associated with each end node. The forces and mass from each element is added to the corresponding nodes of the cable, and the acceleration of each node is calculated in the OdeFcn.

The cable is influenced by:

The calculation of these forces are more thoroughly explained in CableElDynStiff.

Example configuration excerpt

<Lib
LibName = "marine_elements"
SimObject = "Cable/LumpedMass"
Name = "C"
NumElements = "7"
Density = "3000"
NumericalDamping = "0"
Diameter = "0.1"
E = "117"
DampingRatio = "1"
FluidRho = "1025"
MaxStepLength = "0.01"
MaxTension = "1000"
StepSafetyFactor = "50"
MeanTension = "0"
AdaptationPeriod = "0"
MaterialName = "Trawl/Wire2"
NumFaces = "5"
DrawScale = "2"
/>

Input Ports

Name Width Description
Length 1 The length of the cable.
PosA 3 The position of end A.
PosB 3 The position of end B.
VelA 3 The velocity of end A.
VelB 3 The velocity of end B.

There is no water-velocity input port. The ambient current is taken from the Environment shared resource, which the cable queries at the mid-point of each element.

Output Ports

Name Width Description
ForceA 3 The force from end A of the cable.
ForceB 3 The force from end B of the cable.
PosA 3 The position of end A.
PosB 3 The position of end B.

Configuration parameters

Name Width Description
NumElements 1 Number of internal mass elements (Default: 2).
Density 1 The density of the cable [kg/m³] (Default: 1100). @addoption{NumericalDamping, 1, Added numerical damping [1/s], a dashpot between the two end nodes of each element, relative to the neighbour nodes and never to the water or the earth (owner ruling 2026-11-04\, MARE-0447). The force on end A is \f$\vec F_A = c (\vec v_B - \vec v_A)\f$ and on end B \f$\vec F_B = -\vec F_A\f$\, with \f$c = k m_e / 2\f$\, \f$k\f$ the numerical damping factor and \f$m_e\f$ the element mass as integrated. On an inner node of a uniform cable that is \f$\vec a = k (\overline{\vec v}_{neighbours} - \vec v)

This SimObject is referred to as Cable/LumpedMass